2000 jeep grand cherokee crankshaft position sensor replacement

2000 jeep grand cherokee crankshaft position sensor replacement

Jeep grand cherokee crank sensor replacement - duration 1451. Jeep crankshaft position sensor alternate access for repair - duration 450.

Jeep crankshaft position sensor alternate access for repair - duration 450. Jeep grand cherokee crank sensor replacement - duration 1451.

0l crank sensor replacement, xj, jeep would run fine and after heating up, it would stall out and not start again until it cooled down for quite sometime.

Code 11 was pulled from the obd i computer (loss of camshaft or crankshaft position sensor). Com it was determined that the crankshaft position sensor was most likely.

The average cost for a jeep grand cherokee crankshaft position sensor replacement is between 212 and 282. Labor costs are estimated between 119 and 151 while parts are priced between 93 and 131.

I thought it was the crankshaft position sensor but it turned out to be the camshaft cam shaft position sensor. These are also known as a hall effect sensor or a distributor pickup coil.

Jeep grand cherokee crankshaft position sensor replacement at your home or office.

Jeep grand cherokee camshaft position sensor replacement costs between 102 and 266 on average.

The crankshaft position sensor is mounted at the back of the engine, at the top of the bellhousing, slightly left of center (intake manifold side).

How to replace crank sensors in a jeep cherokee by christian killian if your jeep cherokee stalls unexpectedly, runs rough, starts hard, or doesnt start at all, you may have a bad crankshaft position sensor (cps).